How to replace a Gen 5 dodge viper window regulator

Jan 5

2013 – 2017 Dodge Viper Window Regulator Replacement

Watch the video below to see an efficient removal and replacement of the window regulator with upgraded robust components.

Step 1: Door Panel Removal (The Easiest Viper Generation)

Access Screws: Pop out the two plastic covers on the door panel to reveal two T-25 screws.
Panel Detachment: Remove the screws, then carefully pop the door panel out from its clips.
Disconnects: * Slide out the small safety tether by pushing the edge in.

Step 2: Teardown and Window Extraction

Speaker Removal: Remove the three 8mm bolts to take out the door speaker.
Alignment for Removal: Before disconnecting the motor, adjust the window height so the two mounting bolts align with the access holes in the door frame.
Front Pin: Reach through the speaker hole to pull the pin holding the front of the window to the regulator.
Rear Bolts: Roll the window up to access the two rear mounting bolts. Pro Tip: Use a magnetic 10mm socket to prevent dropping bolts into the door cavity.
Glass Removal: Pry the window from the regulator by hand and lift the glass up and out of the door.

Step 3: Regulator and Motor Removal

Bracket Removal: Use a T-25 to remove the four screws holding the interior support bracket.
Hardware: * Remove the two nuts for the rear regulator track.

Stud Management: If the mounting studs come out with the nuts, use a 3mm Allen Key or a stud remover (or two jammed 6x1mm nuts) to separate them on the bench before reinstallation.
Extraction: Carefully slide the entire assembly forward and maneuver it out, being mindful of the internal cables.

Step 4: Installation of Upgraded Regulator

The Upgrade: Havik utilizes robust regulators (from Power Window Repair) with strengthened cable points to prevent common plastic failure.
Positioning: Maneuver the new assembly into the door. Start by getting the front track in, followed by the motor and back track.
Securing: Hand-tighten all nuts for the motor and tracks before a final snug down to ensure proper alignment.
Window Install: Drop the glass back in. Start by angling the front mount into the track through the speaker hole. Note: Check your window bosses; if they are worn, replace them now.

Step 5: Reassembly and Window Relearn

Panel Prep: Ensure all metal clips and plastic pins are correctly seated in the door, not stuck in the bracket.
Connections: Reconnect the tether, door cable, window switch, and electronic release. Snap the panel into place.
Relearn Procedure (Critical Step):

Roll the window down manually (do NOT use auto-down) and hold the switch down for 5 seconds.
Roll the window up manually (do NOT use auto-up) and hold the switch up for 5 seconds.
Note: Ensure you are not clicking the switch into the "Auto" detent during this hold, or it will not take. You may need to repeat this multiple times.

Michael Kuchavik